09-29-2000, 09:18 PM | #1 |
Guest
Posts: n/a
|
I keep getting a error on start up stating Deep6: Malloc error never even get into the game... I have an AMD Athlon 700 with 128 megs ram, SG 128 PCI, 3DFX Vodoo 3 with 16 megs ram, nothing but bare essentials loded into memory, a DVD/CD Player, Full install, Direct X 7.0A, newest Video and sound drivers all Direct X compatable.. Still get this error instaalled the game 3 times and ran defrag twice still NO GO!!
|
09-30-2000, 09:36 AM | #2 |
Guest
Posts: n/a
|
This was posted on heuristic park board also. They were recommending disabling tsr's but I don't know if it worked. I'd check there with the other person and see what you folks have in common.
|
10-02-2000, 08:56 AM | #3 |
Guest
Posts: n/a
|
I had the same prob. After checking my system's virtual memory setup, I found that I had set to manual and it was too low. So I set it to allow Windows to adjust virtual memory and I haven't had a problem since.
V. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Deep6?? | Mierkos | Wizards & Warriors Forum | 15 | 04-18-2005 07:42 PM |
What the... (IE error) | slicer15 | General Conversation Archives (11/2000 - 01/2005) | 2 | 07-12-2003 09:23 AM |
Deep6 error?? | Norin | Wizards & Warriors Forum | 10 | 03-03-2003 06:17 AM |
D3D command line parameter: deep6.exe -LIGHT=n / n | Fallagar | Wizards & Warriors Forum | 4 | 05-30-2001 10:04 AM |
DEEP 6: MALLOC??!! Help!! | Wintermute | Wizards & Warriors Archives | 1 | 11-21-2000 04:24 AM |