Ironworks Gaming Forum - View Single Post

Morgeruat · 08-31-2005, 12:56 AM

a couple of problems, I can't locate the motherboard part # or manufacturer so I can't track down the wiring diagram I need, I'm still using glasses that are about 8 years out of date, so even with very good light seeing the print is extremely difficult (I'm practically blind without them so removing them to work on it isn't an option) and I don't know if the images make it clear but the text is very tiny and overlapping (typical for a M-board of course) When I built my machine I had a wiring diagram from the manufacturer to work off of.

The case connectors I've got to worry about are the HDD LED, Reset Switch, Power swutch, Power LED, and speaker.

{edit} I've been using trial and error, but so far haven't had any success.

[ 08-31-2005, 12:56 AM: Message edited by: Morgeruat ]

08-31-2005, 12:56 AM	#4
Morgeruat Jack Burton Join Date: October 16, 2001 Location: PA Age: 43 Posts: 5,421	a couple of problems, I can't locate the motherboard part # or manufacturer so I can't track down the wiring diagram I need, I'm still using glasses that are about 8 years out of date, so even with very good light seeing the print is extremely difficult (I'm practically blind without them so removing them to work on it isn't an option) and I don't know if the images make it clear but the text is very tiny and overlapping (typical for a M-board of course) When I built my machine I had a wiring diagram from the manufacturer to work off of. The case connectors I've got to worry about are the HDD LED, Reset Switch, Power swutch, Power LED, and speaker. {edit} I've been using trial and error, but so far haven't had any success. [ 08-31-2005, 12:56 AM: Message edited by: Morgeruat ] __________________ "Any attempt to cheat, especially with my wife, who is a dirty, dirty, tramp, and I am just gonna snap." Knibb High Principal - Billy Madison