Ironworks Gaming Forum - View Single Post

Ajia Mal'Kreig · 07-31-2002, 11:01 PM

GForce 3 (Xtasy TI 500) nVidia 29.42 drivers, ASUS RAMBUS MB, 512MB RAM, P4@2G = water looks the same with everything turned on.

However, after I installed patch 2 this evening, I am now getting snow on the ground in the Acadian Islands areas (area around Fort Pelagiad). Was the snow always there and I never saw it because I was trying to get better frame rates or is this a new problem?

PS: I had to remove my Adaptec 2940U SCSI controller and SMC 10/100 Ethernet card to keep the game from locking up if I moused too fast over the menus or left the menus up while I went to run errands. No more pressing F5 every 5-10 minutes and rebooting, so I can live with the snow...

07-31-2002, 11:01 PM	#13
Ajia Mal'Kreig Dungeon Master Join Date: July 5, 2002 Location: Rhode Island, USA Age: 64 Posts: 94	GForce 3 (Xtasy TI 500) nVidia 29.42 drivers, ASUS RAMBUS MB, 512MB RAM, P4@2G = water looks the same with everything turned on. However, after I installed patch 2 this evening, I am now getting snow on the ground in the Acadian Islands areas (area around Fort Pelagiad). Was the snow always there and I never saw it because I was trying to get better frame rates or is this a new problem? PS: I had to remove my Adaptec 2940U SCSI controller and SMC 10/100 Ethernet card to keep the game from locking up if I moused too fast over the menus or left the menus up while I went to run errands. No more pressing F5 every 5-10 minutes and rebooting, so I can live with the snow...