[PeeWee]

Hi, I am creating and using new walls but am not quite sure if I'm doing everything correctly. I'm using the Ezwall editor to get my main imaged formatted(chopped up) to be properly used within DC( I didn't read the help files thoroughly either =/ , I skimmed.).

I have a few walls made and already in place. Some of my walls however have mirrors on them. If I'm looking at one wall with the mirror on it, the next wall seems to have one too. I'm looking at the mirrored wall from two steps back. No other adjacent walls have mirrors yet it seems as if they do. Is this common?

I don't know what else to say to explain it better.
OOOXOOO
IIIIIII
IIIIIII
IIIMIII

If the above little diagram is aligned right when it's submitted, The O's are walls without mirrors while X is the one with a mirror on it. M is where I am, and from my spot, I see quite a few mirrors where the O's are at. I's are empty spaces. only the two adjacent walls to the X show the mirrors almost as bright as day.

I'd appreciate it if I could get a brief explanation if ya can on how it works. If it's one of those complicated things, then don't worry about me trying to figure it out, I won't =p...
I just felt like I needed to bring it up in case it's not suppose to be like this...though something inside is telling me the reply back is gonna say it's normal.

I'm enjoying the program too btw. Too much versatility for a noobie though. Got tons I wanna do with it yet I have to make walls and that even takes ALOT of time. Got to get into learning overlays and then incorporating gifs(also finding decent programs to do it with). Hopefully by then, the combat system will be further enhanced so I can make a progressive step into scripting.

Thanks for reading.